You must have the right tools for the job. Make sure you have the right tools and in good condition before starting work. This includes all the tools for the terminations, for the cables and the testing equipment, do you know if the test leads are in good condition? without them, the well-done terminations will obtain satisfactory measurements in the tests. More and more installers are acquiring their own tools, such as car mechanics, and they say that they ensure that the tools are well maintained.
Dust and dirt are his enemies, it is very difficult to place terminations or make splices in a place with dust. Try to work in the cleanest place possible; use lint-free cloths (do not use swabs or cloths made with old t-shirts) to clean each connector before connecting or testing it; do not work near the heating grilles, as these will blow dust on you continuously; place covers on connectors and connection panels when not in use; keep them covered and clean.
Do not polish excessively. Contrary to what everyone thinks, polishing too much is as bad as polishing too little. The ceramic splint in most connectors today is much stronger than fiberglass. By polishing it too much, the fiber weakens and thus obtains a surface of the concave fiber, instead of convex as it should be, increasing the losses. A few passes are all that is needed.
Fiber optic technician pay
Change granulated sandpaper regularly. When polishing, debris and dirt accumulate on the sandpaper, which can cause problems after polishing many connectors and resulting in poor terminations. Verify the manufacturer's specifications.
Dust and dirt are his enemies, it is very difficult to place terminations or make splices in a place with dust. Try to work in the cleanest place possible; use lint-free cloths (do not use swabs or cloths made with old t-shirts) to clean each connector before connecting or testing it; do not work near the heating grilles, as these will blow dust on you continuously; place covers on connectors and connection panels when not in use; keep them covered and clean.
Do not polish excessively. Contrary to what everyone thinks, polishing too much is as bad as polishing too little. The ceramic splint in most connectors today is much stronger than fiberglass. By polishing it too much, the fiber weakens and thus obtains a surface of the concave fiber, instead of convex as it should be, increasing the losses. A few passes are all that is needed.
Fiber optic technician pay
Change granulated sandpaper regularly. When polishing, debris and dirt accumulate on the sandpaper, which can cause problems after polishing many connectors and resulting in poor terminations. Verify the manufacturer's specifications.
No comments:
Post a Comment